Support Center > Knowledgebase> Tagged: Vacuum
Tag: Vacuum
4 Articles
Orange arrow The vacuum tube on the APR-5000-XL does not go to UP or FREE modes?

643 views
  Possible Causes: 1) Broken or leaking tube connection to air cylinder. 2) Bad vacuum pump. 3) Bad air cylinder. Possible Solutions (corresponding to the Causes #): 1) Check tubing from vacuum pump in the chassis to air cylinder in the head. 2) Replace vacuum pump (APR-VPC). Replacement instru...
Tagged: Vacuum, up, pump


Orange arrow Is there no or low vacuum pickup on the APR-5000-XL?

487 views
  Possible Causes: 1) Bad vacuum pump. 2) Clogged vacuum filter. 3) Clogged vacuum tube or elbow fitting. Possible Solutions (corresponding to the Causes #): 1) Check for vacuum pump activation (sound). Replace vacuum pump (APR-VPC). Replacement instructions: APR-VPC - Airflow.pdf 2) Replace fi...
Tagged: Vacuum, pump


Orange arrow Can I use the same reflow and vacuum nozzles as my old APR-5000 model on my new Scorpion model?

597 views
  Yes! The Scorpion Rework System uses the same reflow and vacuum nozzles as its APR-5000 predecessor....
Orange arrow The vacuum tube on the APR-5000-XL is stuck and/or binding when in FREE mode?

341 views
  Possible Causes: 1) Flux build up in vacuum tube bushing and/or collet. 2) No vacuum to the bottom inlet on air cylinder. 3) Bad air cylinder. 4) Vacuum tube is bent. Solutions (corresponding to the Causes #): 1) Remove the vacuum tube and carefilly clean vacuum tube bushings with alcohol or ...

Page: 1 of 1